Rotating a calf at parturition to aid in delivery

 Resize text         Printer-friendly version of this article Printer-friendly version of this article

Throughout the course of a calving season, some heifers and a few cows may need assistance at calving time. If the heifer is not making real progress within one hour of the first appearance of the water bag or baby calf feet, she probably will need assistance. The adult cow should deliver her calf within a half hour after the appearance of the water bag or baby calf feet. Pulling should not be done until the cow has been examined and cervical dilation is complete. Also the producer should check to see if twins or a fetal “monster” (deformed calf) is the reason for the difficult birth. Pulling on a calf should be done only when the presentation and posture of the calf are normal. This applies both to a normal anterior (forward) position and a posterior (backward) position. KNOW YOUR LIMITATIONS. If the delivery is more than you can handle with relative ease, CALL YOUR VETERINARIAN IMMEDIATELY!

A large calf, with shoulders too wide for the pelvis, is sometimes held up at this stage. If so, pull one limb only so that the elbow and shoulder of one limb only enter the pelvis. Then, while the pull on the limb is continued, the other limb is treated in the same way until both feet project equally from the genital passage. Now apply traction on both limbs and on the head until the head protrudes from the vulva, and from this stage the principle traction is exerted on the limbs again. It can be seen that traction on both limbs at the same time will result in both shoulders entering the pelvis at once.


(Figure 1. Pulling both shoulders (or both hips if the calf is backwards) through at the same time may result in shoulder lock or hip lock.)

The pelvis has an oval shaped opening with the largest dimension being the vertical axis, and the smaller dimension is the horizontal width. If the shoulders of a large birth weight calf can be made to enter on a slant and can be pulled through in that position, delivery will be made easier. Apply traction that will allow the calf to be turned about 90 degrees so that the widest part of the shoulders will match the largest dimension of the pelvic opening.


(Figure 2. The chest or torso has a greater vertical dimension than horizontal).

After the shoulders have passed the pelvic opening, the calf can be returned to the normal upright position because the torso is larger in the vertical dimension.

Hiplock is the next likely obstruction that is met when pulling a calf. If the passage of the hind end of the calf presents any difficulty, the body of the calf should be grasped and twisted to an angle of about 45 degrees. Delivery is then made with the calf half-turned on its side. This allows for easier passage of a calf with well developed stifle joints.


(Figure 3. Rotating the calf to match the thick part of the hips or stifle joint with the greatest dimension of the pelvic opening.)

Again: KNOW YOUR LIMITATIONS. If the delivery is more than you can handle with relative ease, CALL YOUR VETERINARIAN IMMEDIATELY!

Comments (0) Leave a comment 

e-Mail (required)


characters left


The Krone BiG X features a MAN engine and a revolutionary crop flow design, VariStream. VariStream adapts the cross section ... Read More

View all Products in this segment

View All Buyers Guides

Feedback Form
Leads to Insight